Most of the time, businesses would spend lots of money to purchase their forklifts. It is essential, therefore to take good care of your machine to protect your investment into the long run. It is a good idea to know the procedures that are carried out during the care and maintenance of this piece of machine.
Amongst the best ways to tell how good the engine is performing is by starting the lift truck up and listening carefully to see how it works. Like for instance, if there are any knocks or misses, the machinery is faulty and this must raise some concerns. Also listen carefully for any squealing noise which come from the belts because these noises will provide you with a lot of information.
When performing maintenance, some of the main components you would have to pay attention to comprise the safety warning devices, horn, gauges, the overhead guard and the lights. Any burnt out light bulbs or faulty components must be replaced as soon as they are noticed. It is also imperative to check the wiring.
When the above parts have been checked thoroughly, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Each and every cell of the battery should be checked in order to make certain that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machine and after that change the filters. The hydraulic filter, the transmission filter and the fuel filters must be replaced regularly. Prior to fitting them, be sure to write the date on the new filters by utilizing a permanent marker to be able to keep track.
Once the oil change has been done and new filters have been fitted, visually check the drive axle from beneath the equipment. Be certain to grease the axle if there is any grease fitting. Check the engine belts for any cracks or frays. If you find any, fix the problem accordingly. Then, check every other component of the machinery including the wheels. If any type of issue or fault is detected, be certain to address it immediately in order to make certain the machine is working at its safest and optimum levels.